Answers are grounded in this paper and cite their sources.
In cross-basin water conveyance channel projects in cold and arid areas, solving frost heaving damage is a key issue. Large-scale prefabricated water conveyance structures can be effectively controlled, and the performance of interplate sealing materials is the key to determining whether leakage occurs. This study examines the mechanical properties of sealing materials used between lining plates of prefabricated channels through physical tests on both the sealing materials and composite members under freeze–thaw cycling conditions. A comprehensive performance loss retention rate ( R ) is proposed as an evaluation index for material performance. There were several key results. First, in our study of sealant materials, after nine freeze–thaw cycles, the flexural capacity of silicone rubber sealant (SR) decreased by 30.13%, its compressive modulus decreased by 44.5%, and its tensile strength decreased by 25.3%. Polysulfide sealant (PS) and polyurethane sealant (PU) also exhibited degradation, whereas modified silane sealant (MS) showed the least reduction in flexural and tensile strength, with decreases of only 10.12% and 6.7%, respectively. Second, in our study of the microscopic mechanism, we found that freezing causes localized shrinkage in the materials and a reduction in pore structure. However, after nine freeze–thaw cycles, the number of large-pore structures increased, while that of small-pore structures decreased. The proportions of pores with a Feret diameter less than 5 μm in SR, MS, PS, and PU were 3.28%, 2.45%, 3.3%, and 4.26%, respectively. Third, in the analysis on composite members, bending tests found that the strength loss of SR material was 75.04%, while MS exhibited the smallest loss at 32.02%. In compression tests, however, SR showed the least modulus attenuation. In tensile tests, MS material demonstrated the highest bonding strength, with only a 25.4% decrease—the smallest among the materials—and an R -value as high as 81.41%. Finally, we conducted numerical simulation, where the mutual contact model of soil lining was introduced, and the corresponding physical model test was established. It is found that the numerical test results are larger than the actual test results, but the simulation results are basically consistent with the physical test results. The comprehensive comparison shows that the MS material performs best among the four sealant materials.
No takes yet. Share an insight, caveat, or question.
Wang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: