Answers are grounded in this paper and cite their sources.
The design of most geotechnical structures (retaining walls, foundations, tunnels, dams, natural and anthropogenic slopes) relies on finite-element models to predict deformations and performance over time. Advanced numerical analyses utilizing hyperbolic elastoplastic constitutive models are used to represent the measured deformations. As a result, the definition of the complete stiffness degradation curve of a soil or soft rock has taken on increased importance. The hardening soil model with small-strain stiffness (HSS) is gaining widespread use because it offers improved agreement with field measurements and can be implemented with relatively little computational or modeling complexity. The model, however, depends on accurate definition of the small-strain shear modulus ( G 0 ), a reference shear strain ( γ 0.7 ), the unload–reload stiffness ( E u r ), and the secant stiffness at 50% of deviatoric strength ( E 50 ), which are traditionally obtained through laboratory testing. Historically, the G 0 of a soil or soft rock is obtained using either downhole or cross-hole seismic testing. Seismic testing in situ is limited in that it can only provide a single value of the linear-elastic shear modulus, G 0 , for each test interval. Complete nonlinear-elastic behavior must be obtained through advanced laboratory testing using either a resonant column or a triaxial test with local strain sensors. However, this testing is not always possible in heavily overconsolidated soils or soft rocks that do not readily lend themselves to sampling or laboratory testing. The proposed method describes the estimation of G 0 , the reference shear strain γ 0.7 , and a corresponding E 50 from nonlinear field data obtained from pressuremeter unload–reload cycles, normalized to a common reference stress. It will be shown that in situ test data are sufficient to characterize the nonlinear-elastic response and provide the parameters required for most hyperbolic elastoplastic constitutive models. The proposed analysis has been verified using seismic testing (downhole determination of G 0 ) and numerical simulation of a pressuremeter field test.
No takes yet. Share an insight, caveat, or question.
Sharma et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: