Answers are grounded in this paper and cite their sources.
Alloying design is pivotal for overcoming the high polarization, severe self-corrosion, and chunk effect that limit the anode efficiency and specific capacity of magnesium anodes in Mg–air batteries. This study demonstrates the anode efficiency and specific capacity of the extruded Mg–4Li–1Ca (LX41) alloys, with a focus on the effect of lithium content (1, 4, and 8 wt.%) and the coexistence of dual anodic second phases (Mg₂Ca and β-Li). Among all compositions, the α –Mg–based LX41 alloy designates the highest anode efficiency of 72% and the highest specific capacity of 1542.02 mA·h·g −1 at a discharge current density of 20 mA·cm −2 . This superior performance is attributed to the optimized distribution of fine Mg 2 Ca particles, which possess a lower Volta potential than the α -Mg matrix and promote anodic activation without forming continuous corrosion pathways. Concurrently, a relatively intact discharge product layer (MgO, Mg(OH) 2 and CaCO 3 ) forms on the LX41 surface, effectively suppressing self-corrosion and stabilizing the discharge process. In contrast, LX 11 and LX81 suffer from a pronounce severe chunk effect driven by exfoliation corrosion, caused by the preferential dissolution of Mg 2 Ca and the Mg 2 Ca/ β -Li phase, respectively. Equilibrium calculations indicate that Li does not form insoluble products during dissolution. Instead, Li + diffuses into the electrolyte, thereby enhancing both the discharge potential and the diffusion kinetics of the anode material. Thus, the study takes an insight into the new interfacial diffusion mechanisms and offers a rational design strategy for high-performance Mg-air battery anodes.
No takes yet. Share an insight, caveat, or question.
Xu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: