Answers are grounded in this paper and cite their sources.
Precise control of step-height discrepancies at mating surfaces is paramount in aircraft assembly, directly impacting aerodynamic efficiency and structural integrity. Traditional tolerance assignment for fiducial markers often relies on uniform, empirically derived bounds, which fail to account for the geometric relationship between marker deviations and the resulting step-height errors. This paper proposes a lightweight, convex optimization based tolerance design method tailored for step-height control in large-scale fuselage assembly. By recognizing that, for long-span components under preliminary alignment, step-height is dominantly governed by in-plane translations and yaw-like rotation, we adopt a reduced three-degree-of-freedom modeling approach. Within this physically motivated subspace, we first construct a feasible pose region using a full-factorial design of experiments and convex set analysis, ensuring compliance with a prescribed maximum step-height. For each fiducial marker, the tolerance radius is then computed as the solution to a max-min optimization problem—equivalent to the inradius of its reachable region in the mating plane. This yields a non-uniform, location-specific tolerance scheme that is both physically interpretable and computationally efficient. On the available 3.0 m mockup data, 12 markers, and 334 interface points were used, and the plotted radii span approximately 0.07–0.84 mm (a 12-fold range)—quantifying the intuitive notion of geometric leverage in a rigorous actionable form.
No takes yet. Share an insight, caveat, or question.
Hao et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: