Answers are grounded in this paper and cite their sources.
Biomimetic nanopillar surfaces have attracted attention for their ability to induce bacterial cell death through physical damage to bacterial cells. However, the mechanical durability of polymeric nanopillar surfaces and their bactericidal performance after wear remain insufficiently understood. In this study, cyclo-olefin polymer (COP) nanopillar surfaces with nominal heights of 100, 200, and 300 nm were fabricated to investigate the effects of point-contact wear on surface morphology and bactericidal performance. Friction and wear tests were performed using a nylon ball under a normal load of 0.49 N for 100 sliding cycles. The nanopillar surfaces exhibited lower dynamic friction coefficients than flat COP, with no clear dependence on nanopillar height. Scanning electron microscopy (SEM) and atomic force microscopy (AFM) observations revealed nanopillar tilting, tip deformation, and height reductions of approximately 57−70% after wear. Despite these morphological changes, the viable cell ratios of Escherichia coli on the nanopillar surfaces remained 10.0−12.8% after wear. The value was substantially lower than on worn flat COP (67.4%). These findings indicate that COP nanopillar surfaces can maintain low viable cell ratios after substantial wear-induced morphological changes, highlighting the importance of evaluating both mechanical durability and bactericidal performance for practical applications.
No takes yet. Share an insight, caveat, or question.
Kawashima et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: