Answers are grounded in this paper and cite their sources.
Studies on electric scooters equipped with 4 × 4 independent suspension systems remain limited, and no comprehensive design approach has been reported that addresses the use of common suspension modules across different chassis and passenger configurations. In this study, a modular 4 × 4 electric scooter was converted from a single-occupant to a two-occupant configuration without modifying the existing front and rear suspension modules, and the effects of this conversion on critical vehicle design parameters were investigated. The influence of the modified vehicle geometry on steering kinematics was evaluated using the Ackermann steering principle, while the structural behavior of the chassis under different loading conditions was analyzed using the finite element method. Although the overall vehicle length increased by approximately 27% in the two-occupant configuration, the existing suspension modules remained applicable, and no wheel–chassis interference occurred at the maximum steering angle. The structural analyses showed that the changes in the center of mass and load distribution resulting from the addition of a second occupant increased the stress and deformation levels, particularly in the central and rear regions of the chassis. Nevertheless, the maximum equivalent stresses obtained for both configurations remained below the yield strength of the material, while the corresponding safety factors satisfied the recommended limits reported in the literature. The results demonstrate the adaptability of common suspension modules to different chassis configurations and highlight the importance of an integrated assessment of geometric, kinematic, and structural parameters in modular vehicle design.
No takes yet. Share an insight, caveat, or question.
Polat et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: