Answers are grounded in this paper and cite their sources.
This study aimed to perform a theoretical finite element analysis comparing the biomechanical effects of unilateral (uni-VF) and bilateral vertebral fixation (bi-VF) using polymethylmethacrylate following individualized mini-hemilaminectomy–corpectomy (iMHC) of the canine thoracolumbar spine, focusing on range of motion and stress distribution. Using computed tomography data from a healthy Beagle dog, the following three-dimensional finite element models of the T12–L4 vertebrae were generated: (1) intact, (2) left-sided iMHC without fixation, (3) uni-VF (left side only) using 2.4-mm locking head screws embedded in polymethylmethacrylate after left-sided iMHC and (4) bi-VF using bilateral 2.4-mm locking head screws and polymethylmethacrylate after left-sided iMHC. Each model was subjected to a pure moment force equal to 2 N × m in six directions. Range of motion and equivalent stress were quantified and visualized at both treated and adjacent intervertebral levels. At the treated level, bi-VF resulted in markedly lower range of motion than uni-VF, accompanied by small increases in adjacent-segment range of motion. Equivalent stress in adjacent discs was slightly higher following bi-VF than following uni-VF but remained small relative to the reduction in range of motion at the treated level. Bilateral vertebral fixation provided greater stabilization than uni-VF. Under the evaluated conditions, the associated increases in adjacent-segment range of motion and stress were minimal, indicating a limited biomechanical increase in adjacent-segment loading.
No takes yet. Share an insight, caveat, or question.
KIKUCHI et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: