Answers are grounded in this paper and cite their sources.
Developing efficient and robust electrocatalysts for the hydrogen evolution reaction (HER) is essential for sustainable hydrogen production through alkaline water electrolysis. Herein, Ni3Se2 nanosheet assemblies were directly grown on nickel foam via a facile solvothermal method, in which the morphology and electrocatalytic properties were effectively regulated by varying the amount of MnSO4 precursor. The introduction of an appropriate amount of Mn precursor markedly altered the growth and assembly of Ni3Se2 nanosheets, resulting in well-defined flower-like hierarchical architectures (approximately 0.5–2 μm in size) with abundant exposed active sites and favorable pathways for electrolyte penetration and gas release. Benefiting from the optimized nanosheet architecture, the Ni3Se2 electrode prepared with 0.010 mmol MnSO4 exhibited the best HER performance in 1.0 M KOH, requiring a low overpotential of only 61 mV to achieve a current density of 10 mA cm−2, substantially lower than those of Mn-free Ni3Se2 (121 mV) and bare nickel foam (177 mV). In contrast, further increasing the MnSO4 amount to 0.020 mmol resulted in a higher overpotential of 106 mV, highlighting the importance of controlled precursor addition for optimizing the electrode architecture and catalytic performance. These results demonstrate that Mn precursor-mediated morphological regulation provides a simple and effective strategy for constructing highly active Ni3Se2-based electrodes for alkaline hydrogen evolution.
No takes yet. Share an insight, caveat, or question.
Zhang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: