Answers are grounded in this paper and cite their sources.
Acoustic comfort is a core determinant of indoor environmental quality, and the porous absorbers that provide it—suspended ceilings, wall linings, and partition infill—are a large, recurring material demand in buildings. Textile and post-consumer carpet waste are the two largest fibrous waste streams proposed to meet it, yet the literature treats them separately. This review compares both within a single framework and examines whether they can be combined. Carpet waste is not a fiber fraction but a layered product: pile yarn may be less than half the mass, the rest being backing polymer, styrene-butadiene rubber (SBR) latex, and inorganic filler—and this composition, not the fiber, governs the recycling routes. Reported findings on the acoustic role of SBR appear to conflict—raising absorption at 2–3 kHz, reducing it at higher content, or removing it entirely—but the disagreement resolves once the studies are recognized as different material systems. The processing route, often overlooked beside feedstock, emerges as a decisive, and underappreciated factor—plausibly a main source of the conflicting results—yet the two remain confounded in every published comparison, so their relative weight cannot yet be established. Because absorption depends on fiber fineness at high frequencies and on thickness and air gap at low frequencies, single-number ratings such as NRC obscure the differences that matter. A low-impedance textile facing a denser carpet core is predicted to broaden the absorption band, but no such panel has been built or measured.
No takes yet. Share an insight, caveat, or question.
Atcı et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: