Answers are grounded in this paper and cite their sources.
Abrasive waterjet peening (AWJP) is a promising surface treatment technique widely utilized to enhance the surface integrity of metallic materials. An effective peening strategy should balance surface quality and deep subsurface hardening while avoiding abrasive embedment, microcracking, and phase instability. This balance is particularly challenging for laser directed energy deposition (L-DED) Ti-6Al-4 V (Ti64), because its as-deposited acicular microstructure presents a notable barrier to the effectiveness of conventional single-stage peening. To address these issues, a dual-stage AWJP process was proposed to enhance the surface integrity and strengthening performance of L-DED Ti64. The strengthening mechanisms in the second stage were evaluated across three distinct intensities. In terms of subsurface mechanical response, the dual-stage process at a proper intensity achieved a maximum hardness of 475 HV at 50 μm (6.5% enhancement over the conventional single stage) and maintained the highest hardness throughout the near-surface region, remaining at 425 HV at a depth of 150 μm. EBSD analysis further showed that the deformed layer increased from approximately 13 μm after single-stage steel-shot peening to approximately 45 μm after the optimized dual-stage treatment. However, under high-intensity impacts, EBSD phase indexing indicated a thin retained β-phase signal at the topmost surface, suggesting possible local phase instability induced by severe plastic deformation. Ultimately, these findings validate the dual-stage AWJP approach as an effective method to overcome the limitations of single-stage treatment, providing a strategic balance of surface quality, deep-layer hardening, and phase stability for high-performance aerospace repairs.
No takes yet. Share an insight, caveat, or question.
Zhang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: