Answers are grounded in this paper and cite their sources.
Synthetic ester-based hydraulic fluids are gaining attention in marine engineering as environmentally friendly alternatives to mineral oils. However, the viscosity increase induced by high hydrostatic pressure and low temperature in deep-sea environments significantly degrades pump performance, yet systematic high-pressure viscosity data for such fluids remain scarce. Moreover, manufacturer efficiency data are measured under land-based conditions with mineral oils, which differ substantially from actual deep-sea conditions. To address these issues, this study measures the high-pressure viscosity of a synthetic ester-based hydraulic fluid over 4–60 °C and up to 60MPa, and represents it by a 5-parameter model with R2=0.999941 and a mean absolute percentage error of 1.36%. A general efficiency mapping framework is then developed for positive-displacement pumps and motors and exemplified on an external gear pump; it maps the sample (catalog) condition directly to the target condition through the total viscosity amplification factor k=RKTKp, where the three factors account for fluid substitution, temperature and pressure. The framework contains a single empirical parameter, the viscous friction proportion λref. For the external gear pump λref is obtained, not assumed, from a dual-oil test on a pump of the same series, which gives 0.189–0.232 at the operating point, so λref=0.200 is adopted. The published decompositions for gear pumps give 0.205 and 0.230 at the same point, and over the 13.2–16.1 viscosity range of the test the mapped volumetric efficiency lies 2.6 to 3.4 percentage points above the measurement. Applied to a Concentric W300 3.2 cm3/r gear pump at 6000m, a lumped heat balance gives an oil temperature of 14.9 °C and k=13.22. The volumetric efficiency rises to 98.5%, the mechanical efficiency falls to 83.6%, and the total efficiency drops from 92.0% to 82.4%, a loss of 9.6 percentage points. At 2 °C the total efficiency falls to 67.7%, a transient state that the losses themselves soon remove. The established viscosity model and efficiency mapping framework together provide a practical engineering tool for pump efficiency estimation during the conceptual design and fluid selection stages of deep-sea hydraulic systems.
No takes yet. Share an insight, caveat, or question.
Shuang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: