Answers are grounded in this paper and cite their sources.
The influence of cooling conditions on the microstructure and transverse tensile behavior of friction stir welded NiCoCr medium-entropy alloy was investigated by comparing air-cooled friction stir welding (AFSW) with alcohol–dry ice-assisted friction stir welding (LFSW) under identical nominal welding parameters. Both conditions produced sound joints containing fine, predominantly equiaxed grains in the nugget zone (NZ). Compared with AFSW, LFSW reduced the average grain size from 4.85 to 3.75 µm in the upper NZ and from 4.77 to 3.93 µm in the lower NZ. The finer-grained LFSW joint exhibited a higher yield strength (546 ± 3 MPa) than AFSW (471 ± 3 MPa), while their ultimate tensile strengths remained comparable (828 ± 7 and 836 ± 4 MPa, respectively). In contrast, uniform elongation decreased from 62.9 ± 5% for AFSW to 25.0 ± 2% for LFSW. Electron backscatter diffraction revealed progressive grain subdivision and recrystallization across the base material–thermo-mechanically affected zone–NZ transition in both joints. Digital image correlation further showed that plastic strain was preferentially accommodated outside the refined NZ, with more pronounced spatial strain partitioning in the LFSW joint. These results demonstrate that intensified external cooling promotes NZ grain refinement and increases joint yield strength, but its benefit is offset by reduced deformation compatibility during transverse tension. The comparison establishes the importance of balancing local NZ strengthening with strain accommodation across the entire welded joint.
No takes yet. Share an insight, caveat, or question.
Zhang et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: