Answers are grounded in this paper and cite their sources.
Mg–CO 2 batteries couple electricity generation to the conversion of dissolved CO 2 into solid carbonates, but the material output of these systems is almost always assessed from the precipitate that forms during discharge. However, a fraction of the anodically released magnesium never leaves the liquid phase and is discarded. In this work, we quantify both fractions and show that they can be recovered as complementary product streams. A large‐area membrane‐free Mg–CO 2 cell was discharged for 100 h in 100 L of CO 2 ‐saturated brine seawater, passing 225 Ah of charge. The crude solid was washed to remove soluble seawater salts, enriching the residual Mg 5 (CO 3 ) 4 (OH) 2 ·4H 2 O (hydromagnesite), Mg(OH) 2 (brucite), and CaCO 3 (calcite) fractions. In parallel, the spent electrolyte was concentrated by thermal evaporation and precipitated at pH 8 without additives. The corresponding product was predominantly hydromagnesite. During thermal treatment, carbonate formation drew exclusively from the residual total inorganic carbon retained in the electrolyte. By using a dual‐stream recovery route strategy, a total of 322.6 g Mg was retrieved in the form of carbonate and hydroxide, while approximately 217.9 g CO 2 was mineralized from the system, representing an equivalent carbon dioxide capture rate of 2.18 g CO 2 h −1 . These results establish a feasible route to mineralize CO 2 through the novel Mg–CO 2 brine seawater battery systems, where the electrolyte inventory becomes increasingly important as operation is extended.
No takes yet. Share an insight, caveat, or question.
Garza et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: