Answers are grounded in this paper and cite their sources.
In this research work, a numerical analysis of the effects of genetic algorithm (GA) optimized spiral groove texturing and electrorheological (ER) lubricants on the performance of a hybrid journal bearing with two lobes and a hole entry has been conducted. Twelve configurations formed from two bore geometries, three surface textures and two lubricants are tested under static and dynamic loading. Compared to untextured bearings, the GA-optimized spiral groove designs resulted in increases of 20.5–27.7% in lubricant flow rate and an 8.0–26.5% reduction in frictional torque. Whereas an arbitrarily textured surface degraded the direct stiffness coefficient by up to 58.4%, GA-optimized held the loss to 13.5% at moderate load and produced a 72.1% gain at high load, improving the stiffness to damping ratio ( S D R ) by 85% to nearly seven-fold over the untextured baseline. Activating the ER lubricant further increased the damping coefficient by 8.4–17.9% and the minimum film thickness by up to 14.5%, while reducing flow by less than 0.5%. Relative to the non-optimized texture, the GA-optimized geometry raised the threshold speed by 8.7% at W ¯ 0 = 1.0 , but the threshold speed remained 17.3% below that of the untextured two-lobe bearing. The optimized geometry is therefore optimal only with respect to the chosen objective (threshold speed) among the textured designs, and texturing trades some stability margin for higher flow and lower friction.
No takes yet. Share an insight, caveat, or question.
Yadav et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: