Answers are grounded in this paper and cite their sources.
Euro 7 regulations impose limits on brake wear particle emissions, motivating lightweight low-wear alternatives to cast iron brake disks. High-speed laser cladding (HSLC) enables the fabrication of AlSi7Mg0.6–TiC surface composites, but the effect of its deposition and cooling rates on the resulting particle architecture (carbide size, density and spacing) has not been systematically addressed. This work examines how this architecture influences the tribological response of AlSi7Mg0.6–TiC composites, produced with varying TiC content, laser spot size, and matrix Ti additions, and tested by dry sliding against a silicon nitride ball counterpart. HSLC reduces carbide size during deposition, which is attributed mainly to fragmentation, so the deposited architecture departs substantially from the powder blend; at identical content, a four-fold larger laser spot reduces the median particle size and doubles the number density, producing a fine architecture instead of a coarse one. Tribological performance follows this deposited architecture rather than the TiC content: the coarse one shows higher retention of deformed matrix material and wear debris, lower wear and more stable friction, while the fine one wears about four times more despite twice the particle density. At constant fine architecture, matrix Ti additions do not measurably affect plastic displacement, wear or friction. The coarse architecture also gives a lower and more stable friction coefficient (0.31–0.34 against 0.39–0.43). These results identify the deposited particle architecture as a better descriptor of tribological behavior than the nominal TiC content, and indicate that it can be tailored to the application through the laser spot size.
No takes yet. Share an insight, caveat, or question.
Fichter et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: