Answers are grounded in this paper and cite their sources.
Driven by the demand for complex geometries and efficient rare-earth material utilization, the fabrication of permanent magnets (PM) via additive manufacturing (AM) is now used in R&D design. While the fabrication of PM using AM techniques has been demonstrated, the underlying mechanisms that explain the magnetic properties are not fully understood. In this work, SmCo-based magnets with aluminum and copper binders were fabricated by the cold spray deposition technique. The goal was to optimize fabrication parameters to improve deposition efficiency and magnetic properties. In specific conditions, a decrease in coercivity was observed. Transmission electron microscopy revealed that elemental diffusion within the Cu-rich SmCo 5 phase could explain this decrease in coercivity.
No takes yet. Share an insight, caveat, or question.
Giguère et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: