Answers are grounded in this paper and cite their sources.
Dissolved phosphorus (P) in agricultural runoff drives eutrophication, and low-cost P sorbents are needed. We evaluated fly ash (FA) from domestic wastewater treatment, spent foundry casting sand (CS), and expanded shale (Sh) as P sorbents at pH 5.75 to identify the optimum dose of each and the material with the highest P sorption capacity. After dose and equilibration-time optimization (FA, 800 mg and 48 h; CS, 100 mg and 24 h; Sh, 50 mg and 72 h per 8 mL), sorption–desorption isotherms were measured at 5–25 mg P L − 1 . Per unit mass, Sh retained significantly more P than FA and CS at every concentration (analysis of variance with Tukey’s test, p < 0.001). Its maximum uptake was 231 µg g − 1 , 2.5–2.8 times that of FA (93 µg g − 1 ) and CS (84 µg g − 1 ), and it had the highest distribution coefficients (8.8–40.2 cm 3 g − 1 ). The same ranking was obtained at equal dose and at equal equilibrium concentration. No material released measurable P in the isotherm desorption test, but extended desorption kinetics showed transient release of up to 36% of sorbed P from FA and 51% from CS, whereas Sh released none. FA had the highest extractable Pb, Zn, and Cu, and CS the highest Cr, Ni, and Mo. Expanded shale is therefore best suited as a stable P-retention medium for nursery and agricultural runoff filters, whereas the by-products require modification and metal-leaching assessment before use. Recovering the retained P will depend on demonstrating its plant availability or chemical regeneration.
No takes yet. Share an insight, caveat, or question.
Ahmed et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: