Answers are grounded in this paper and cite their sources.
Corrosion at the cold end of recovery boilers is a well-known issue, although its underlying causes, which may include sulfuric acid condensation and hygroscopic deposits, are not always fully understood. Since the presence of SO 3 (g) directly determines the risk of sulfuric-acid dew-point corrosion, a key practical objective of this work was to determine whether SO 3 (g) is present in recovery-boiler flue gases at cold-end locations where measurable concentrations of SO 2 (g) are found. SO 3 (g) measurements and corrosion-probe tests were carried out under different operating conditions in two types of recovery boilers: a Kraft boiler firing black liquor with relatively low dry-solids content and an ammonium sulfite boiler. In the Kraft boiler, we found that although SO 2 (g) was present in the flue gas, no SO 3 (g) was detected in the cold end. This is because SO 3 (g) reacts with alkali-rich ash, which converts it to solid sulfates and removes it from the flue gas. Thus, the limiting factor in lowering flue gas temperatures in the Kraft boiler was corrosion caused by hygroscopic salt deposits, rather than sulfuric-acid dew-point corrosion. Sodium bisulfate (NaHSO 4 ) can form in boilers firing black liquor with low dry-solids content, and/or with a high S/Na 2 molar ratio in the flue gas. Water uptake by NaHSO 4 was determined to occur at 32–36% relative humidity at flue-gas-relevant water-vapor concentrations (15–35 vol%). In practice, this limits the cold-end carbon steel temperature to around 100–110 °C, depending on the water vapor concentration in the flue gas. In the ammonium sulfite boiler, the situation is different. There, only wood-derived ash is available to capture sulfur, resulting in high SO 2 (g) and SO 3 (g) and a high acid dew point of the flue gas. The measurements make it possible to assess whether flue-gas temperatures can be lowered to recover more energy without causing corrosion in these boilers.
No takes yet. Share an insight, caveat, or question.
Vainio et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: