Answers are grounded in this paper and cite their sources.
Spent LiFePO4 (S-LFP) cathodes can exhibit lithium loss and FePO4 formation, accompanied by increased electrode polarization, which complicates direct recycling. Here, we demonstrate a microwave-assisted thermal regeneration strategy for lithium replenishment, FePO4 conversion, and Fe3+ reduction, accompanied by the formation of a Li3PO4 phase. XRD Rietveld refinement and XPS support changes in phase composition and surface Fe oxidation state, respectively. The regenerated LFP (R-LFP) delivers a specific capacity of 146.0 mAh g−1 at 0.1 C and retains 90.4% of its initial capacity after 600 cycles at 1 C, with reduced polarization (379.8 mV for R-LFP vs. 839.9 mV for S-LFP). In situ EIS shows lower fitted charge-transfer resistance and a smaller variation over a charge–discharge cycle (11.7 Ω vs. 163.7 Ω for S-LFP). DRT analysis is consistent with reduced interfacial impedance, while scan-rate-dependent CV suggests improved Li+ transport kinetics. These results demonstrate that microwave-assisted direct regeneration effectively repairs degraded LFP and mitigates polarization, offering a promising route for direct recycling of spent LFP cathodes.
No takes yet. Share an insight, caveat, or question.
Liang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: