Answers are grounded in this paper and cite their sources.
To keep winter roads safe, chemical agents are normally applied for de-icing and anti-icing purposes. Smarter and more precise spreading that accounts for local concentration variations can lower the total amount required. This paper describes an optical chemometric sensor that measures both the concentration and the mass of sodium chloride (NaCl) solution on road surfaces. Experiments were carried out in an indoor laboratory environment, where NaCl solutions of seven different concentrations were poured onto a diffusely reflecting asphalt surface. Short-wave infrared light was directed onto the surface with an angle of incidence of 25° to suppress the specular reflection on the liquid layer surface, and after a double pass through the liquid layer the diffusely reflected light was collected by a spectrometer. Background subtraction isolates the absorption caused only by the liquid, so that the pure absorbance spectra could be modelled with a Beer-Lambert based approach. An overdetermined equation system, augmented by a bias term to account for residual baseline offset, yields simultaneous estimates of concentration and liquid amount. For the 21 averaged spectra, the RMSE was 2.6% for salinity and 23.3 g/m 2 for solution quantity before post-calibration. Empirical linear post-calibration reduced the corresponding RMSE values to 1.4% and 18.2 g/m 2 , respectively. The distinct properties of various asphalt types and chemicals, the suppression of ambient light, complex environmental variables such as temperature, humidity, and wind, and the low signal-to-noise ratio problem are the challenges for future chemometric sensing of outdoor asphalt pavement.
No takes yet. Share an insight, caveat, or question.
Zhang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: