Answers are grounded in this paper and cite their sources.
Human induced pluripotent stem cells (hiPSCs) are widely used for disease modelling, drug screening, and tissue engineering. However, their culture is highly sensitive to seeding conditions and prone to operator-dependent variability. Bioprinting offers a potential route to standardize early cell seeding and enable spatial control but requires compatible substrates to support cell attachment and maintain pluripotency. Bioprinted deposition of hiPSCs was evaluated as a controlled seeding strategy. To promote cell attachment during bioprinting, three positively charged surface coatings (polyethyleneimine (PEI), poly-D-lysine (PDL), and poly-L-lysine (PLL)) were assessed. Post-deposition, cell attachment, viability, and pluripotency-associated characteristics were analyzed. The ability to generate spatially defined colonies was tested using patterned depositions through bioprinting. Surface coating had a pronounced effect on hiPSC behavior following bioprinting. Among the tested conditions, low concentrations of PLL provided the best overall performance, supporting cell recovery, attachment, and colony formation while preserving pluripotency-associated features. In contrast, PDL was associated with reduced maintenance of pluripotency characteristics, indicating limited suitability for hiPSC culture in this context. Patterned depositions on PLLcoated substrates enabled the formation of spatially defined hiPSC colonies. Substrate compatibility is a key determinant of successful bioprinted hiPSC culture. PLL supports controlled seeding, viability, and maintenance of pluripotency, enabling reproducible spatial patterning. This study establishes a practical workflow for bioprinted hiPSC deposition and highlights the importance of surface chemistry in stem cell biofabrication.
No takes yet. Share an insight, caveat, or question.
Fagiolino et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: