Answers are grounded in this paper and cite their sources.
To address the insufficient corrosion resistance of high-strength and high-toughness 6xxx-series Al alloys for agricultural applications under complex and harsh service environments, a micro-alloyed semi-continuously cast alloy Y (Al-0.9Mg-1.1Si-0.6Cu-0.7Mn-0.2Cr) was investigated in this work. The alloy was first subjected to two-stage homogenization heat treatment and then to two thermal deformation routes, i.e., hot compression at 350–500°C and rolling followed by T6 treatment. OM, SEM, EDS, XRD, potentiodynamic polarization, electrochemical impedance spectroscopy (EIS), and intergranular corrosion tests were employed to study the microstructural evolution and corrosion behavior of the alloy and to reveal the corrosion mechanisms under different thermal deformation conditions. The results show that the as-cast alloy consists of α-Al、\(\:{Mg}₂Si\)、Q(\(\:{Al}₄{Cu}₂{Mg}₈{Si}₇\))及Al(Fe,Mn,Cr)Si phases. After homogenization heat treatment, fine dispersed precipitates form, which not only inhibit grain coarsening but also act as micro-galvanic corrosion sites. The hot compression temperature exerts a significant regulatory effect on the corrosion resistance of the alloy. Combined analysis of the potentiodynamic polarization curves and EIS results indicates that when the hot compression temperature is 400°C, the corrosion current density (\(\:{I}corr\)) of the alloy reaches its minimum value of 7.17216\(\:×{10}⁻⁶A•{cm}⁻²\), and the alloy exhibits the optimal comprehensive corrosion resistance. Meanwhile, the intergranular corrosion of the rolled + T6 alloy is dominated by localized pitting and exfoliation, which is related to the local galvanic coupling of precipitates and defects in the passive film. This study provides a basis for the corrosion resistance control during hot processing and the long-life design of aluminum alloys for agricultural applications.
No takes yet. Share an insight, caveat, or question.
WANG et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: