Answers are grounded in this paper and cite their sources.
Three-dimensional printed composite fabrics (3D-PCF) have attracted attention in apparel and wearable technology, but their durability largely depends on the interfacial adhesion between the substrate fabric and printed polymer. This study investigated the effect of ultraviolet–ozone (UV/O 3 ) surface treatment on the interfacial adhesion of polyethylene terephthalate (PET) substrate fabrics and thermoplastic polyurethane (TPU) in 3D-PCF fabricated by fused deposition modeling (FDM). Surface changes were characterized using FIB–SEM, surface roughness, water contact angle, and ATR–FTIR analyses, while peel and tensile strength tests evaluated adhesion and mechanical properties. UV/O 3 treatment induced micro-etching on the PET surface, with fiber diameter changes within 2%. Surface roughness increased by up to 116%, while the water contact angle decreased from 135.9° to approximately 0°, indicating markedly improved wettability. The the work of adhesion with water increased by at least 4.8 times, and ATR–FTIR showed subtle spectral changes suggesting possible oxidation-related surface changes. Peel strength increased by approximately 200%, reaching a maximum improvement of 239% under the 5 cm–60 min condition. This improvement may result from enhanced mechanical interlocking and interfacial contact associated with microstructural changes and improved wettability, with possible contributions from surface chemical changes. Tensile strength decreased by less than 3%. After 72 h of aging, peel strength decreased by about 30% but remained 138% higher than that of the untreated sample. These findings demonstrate the potential of UV/O 3 treatment to improve PET–TPU interfacial adhesion and highlight the importance of controlling the time between treatment and printing.
No takes yet. Share an insight, caveat, or question.
Han et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: