Answers are grounded in this paper and cite their sources.
Bio‐based epoxy resins face limited industrial adoption due to prolonged room‐temperature curing times. To overcome this, a zinc chloride–ethanol accelerator solution (ZnET; ≈0.43 wt% ZnCl 2 and ≈0.57 wt% ethanol) was added at 1 wt% to two commercial bio‐based systems: Pro‐Set INF 117G (36% bio‐based content) and Entropy Resins CLR (29% bio‐based content). ATR‐FTIR monitoring showed that after 8 h at room temperature, epoxide conversion reached 92.1% ± 0.6% (INF) and 90.0% ± 0.8% (CLR) with ZnET, compared with 63.0% ± 1.5% and 60.2% ± 1.5% in unaccelerated controls. ZnET increased the rate constant of epoxide consumption by a factor of 2.7–2.8 and lowered the DSC cure exotherm peak temperature by approximately 30°C. After 7 days of room‐temperature curing, mechanical testing revealed improvements in tensile strength (INF: +9.8%, CLR: +7.5%), shear strength (INF: +7.3%, CLR: +10.5%), compressive strength (INF: +1.6%, CLR: +6.4%), and impact energy (INF: +14.5%, CLR: +4.5%) relative to unaccelerated controls, with failure modes remaining unchanged. Overall, this simple, low‐cost accelerator substantially shortens room‐temperature cure times of commercial bio‐based epoxies while maintaining or improving mechanical performance.
No takes yet. Share an insight, caveat, or question.
Ullah et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: