Answers are grounded in this paper and cite their sources.
Twisted tape inserts are a well-established passive technique that promotes swirl flow and disrupts the thermal boundary layer, and perforating the tape further modifies the induced turbulence. In this work, the thermal-hydraulic performance of rectangular-cut perforated twisted tape (PTT) inserts combined with Al₂O₃ nanofluid is numerically investigated in a circular tube using ANSYS Fluent. Three perforation geometries, PTT-01 (20 mm × 30 mm), PTT-02 (10 mm × 20 mm), and PTT-03 (5 mm × 15 mm), were examined together with three Al₂O₃ volume fractions (0.05%, 0.15%, 0.30%) over Reynolds numbers of 5000–20,000 under constant wall heat flux. The plain-tube results were validated against the Gnielinski and Petukhov correlations before the insert configurations were evaluated. All PTT geometries enhanced the Nusselt number relative to the plain tube, with PTT-02 producing the strongest heat transfer augmentation (Nusselt number ratio of 1.52 at Re = 20,000) but also the largest friction factor penalty. When the combined benefit was assessed through the thermal enhancement efficiency, PTT-01 with 0.05% Al₂O₃ nanofluid gave the best overall thermal-hydraulic balance, with an efficiency of 0.848. The influence of nanoparticle loading on performance was comparatively small over the concentration range tested. These results indicate that rectangular-cut PTT inserts are an effective passive enhancement technique, but that insert geometry, not nanofluid concentration, is the dominant design variable, and an optimum insert must be selected by weighing heat transfer gain against pressure penalty rather than by maximizing Nusselt number alone.
No takes yet. Share an insight, caveat, or question.
Bhuiyan et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: