Answers are grounded in this paper and cite their sources.
Objectives: In total knee arthroplasty (TKA), orthopedic surgeons carefully determine polyethylene insert thickness to achieve adequate joint stability while preserving bone. Cruciate-retaining (CR) TKA is commonly performed using the measured resection (MR) technique; however, the factors influencing insert thickness in this setting remain unclear. This study aimed to identify factors associated with insert thickness in patients undergoing CR-TKA using the MR technique. Material and Methods: This retrospective single-center cohort study included 59 consecutive patients who underwent CR-TKA using the MR technique between April 2024 and February 2025. Associations between insert thickness and patient-related or surgical factors were analyzed using univariate and multivariate analyses. Results: The results of the univariate analysis showed that the insert thickness was significantly associated with height and femur implant size. The insert were thicker in patients Height ≦153 cm (odds ratio [OR]: 4.5; 95% confidence interval [CI]: 1.3–17; p = 0.0082) and in those receiving femur implants of size ≤7 (OR: 7.7; 95% CI: 0.95–3.6 × 10 2 ; p = 0.038). We performed multivariate analysis regarding the height and femur implant size. Neither the height nor femur implant size was significantly different from the insert thickness in the multivariate analysis. Conclusions: In CR-TKA performed using the MR technique, patient height and femur size may influence insert thickness selection. Short stature (≤153 cm) and smaller femoral implant size (≤7) may be associated with the use of thicker inserts. Awareness of these factors may help optimize intraoperative planning and implant selection.
No takes yet. Share an insight, caveat, or question.
Ishibashi et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: