Answers are grounded in this paper and cite their sources.
To investigate the tribological behavior and failure mechanisms of micro‐arc oxidation‐modified friction pairs over a wide temperature range, two graphene oxide (GO) modified friction pair systems, T1 (Al 2 O 3 /GO‐PTFE/CuO) and T2 (Al 2 O 3 /GO‐PI/CuO), were evaluated at 30, 60, 90, 120, and 150 °C. T1 exhibited lower coefficients of friction (COFs) and wear rates below 90 °C, but both increased sharply above 90 °C due to thermally induced softening of polytetrafluoroethylene, molecular chain agglomeration, and transfer film degradation. From 30 to 150 °C, the COF and wear rate of T1 increased by ≈204.6% and 656%, respectively. In contrast, owing to the superior thermal stability of polyimide, T2 exhibited more gradual increases in COF and wear rate, by ≈151.2% and 391%, respectively. Worn surface observations indicated that thermal softening induced material agglomeration and transfer film instability dominated the wear of T1, whereas progressively intensified abrasive wear dominated T2. These results demonstrate distinct temperature‐dependent tribological behaviors and provide guidance for temperature‐adaptive selection of friction pair materials.
No takes yet. Share an insight, caveat, or question.
Zhang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: