Answers are grounded in this paper and cite their sources.
Enhancing the crack resistance and flexural performance of deteriorated reinforced concrete (RC) beams is essential for extending their service life and ensuring structural integrity. 3D concrete printing (3DCP) offers a cost-effective, formwork-free, and labour-efficient construction approach; however, its limited tensile capacity remains a key challenge. This study proposes a novel strengthening technique for enhanced crack resistance of reinforced concrete (RC) beams comprising 3D-printed fibre-reinforced concrete (3DPFRC) layers with in-process embedded fibre-reinforced polymer (FRP) grid reinforcement at the soffit. The flexural performance of strengthened beams was experimentally evaluated under three-point bending, with parameters including the number of printed layers, interface treatment types, and U-jacket anchorage. Results demonstrate that the proposed FRP-3DPFRC system significantly enhances crack resistance, increasing the cracking load by 47.6%–151.7%, while yielding only marginal improvements in ultimate flexural capacity. The 3DPFRC and embedded FRP grids effectively restrain crack propagation and reduce crack widths. Nevertheless, premature interfacial debonding limits the full utilisation of FRP tensile strength, particularly in multi-layer configurations, where additional layers exacerbate stress concentration and precipitate earlier failure. U-jacket anchorage improves both anchorage efficiency and material utilisation, with the most pronounced improvement in single-layer strengthening schemes. An elastic equivalent section method is developed to predict cracking load, with test-to-prediction ratios ranging from 0.81–1.14. Overall, the proposed technique demonstrates practical effectiveness; however, its performance is governed by interfacial behaviour, highlighting the need for improved bonding and anchorage strategies.
No takes yet. Share an insight, caveat, or question.
Wu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: