Answers are grounded in this paper and cite their sources.
Descriptive geometry (DG) and three-dimensional computer-aided design (CAD) are often taught side by side in first-year engineering graphics without being connected. This paper presents a ten-session laboratory sequence. In each session, students predict a result, construct it by hand on a two-view drawing and check it against a solid model built from the same data. A correspondence map pairs each construction method with the CAD operation that reproduces it. Two engineering-context laboratories, a branch-pipe junction and a sheet-metal hopper, come with reference solutions. We also simulated drafting errors in the hand construction of the line of intersection of two planes. The RMS deviation exceeded 1 mm in 62% of exercise–method combinations whose smallest crossing angle was below 10°, and in 13% when all crossings were at least 30°. This analysis leads to a tolerance and a method-selection rule, proposed for future use. The sequence itself was run in 2025/26 at five universities in Uzbekistan as part of a broader intervention (533 students in 28 groups). In a group-level analysis adjusted for pretest level, experimental groups ended 0.38 levels higher on a three-level graphic-creativity scale (95% CI 0.32 to 0.45). This difference reflects the whole intervention, not the CAD check alone.
No takes yet. Share an insight, caveat, or question.
Vohidov et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: