Answers are grounded in this paper and cite their sources.
Electrical control of the charge state of diamond color centers underpins diamond-based quantum sensing and optoelectronics, yet it remains unresolved whether nanosecond high-voltage excitation acts through the applied field itself or through the electrical discharge at the crystal surface. Here, we investigate the relative contributions by measuring a single polycrystalline CVD diamond in three surrounding media of widely differing dielectric strength—ambient air (∼3 kV mm–1), transformer oil (∼10–15 kV mm–1), and a polyimide (Kapton) encapsulation layer (∼300 kV mm–1)—while varying the pulse amplitude at a fixed 1 kHz repetition rate. In air, the SiV– zero-phonon-line area increases abruptly by ∼650% above a ∼2 kV threshold that coincides with the onset of discharge emission, while the NV– fraction falls by ∼16 percentage points. Kapton encapsulation displaces this threshold to ∼5 kV but leaves the saturated magnitude unchanged, and transformer-oil immersion suppresses both the discharge and the charge-state response, leaving only a weak reversal (ΔSiV– ≈ –20%) above 9 kV. The charge-state response closely tracks discharge onset, persists hundreds of micrometers from the electrode, remains unchanged under polarity reversal, and saturates above the threshold rather than scaling with discharge brightness. The opposite responses of SiV– and NV– are consistent with a proposed downward shift of the effective local Fermi level that favors SiV– relative to SiV2– and NV0 relative to NV–. This interpretation remains qualitative, as the Fermi-level shifts and individual microscopic charge-conversion pathways were not directly determined. These findings highlight the importance of dielectric environment and discharge conditions in electrically induced charge-state control of diamond color centers.
No takes yet. Share an insight, caveat, or question.
Ilkhani et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: