Answers are grounded in this paper and cite their sources.
An integrated thermal management system (TMS) is essential for electric vehicles because battery, motor, and cabin temperatures need to be regulated while minimizing power consumption. However, heat exchanger sizing is often evaluated based on heat pump performance, which may not directly represent vehicle-level energy efficiency. This study proposes a vehicle-speed-dependent heat exchanger design strategy for an electric vehicle TMS by integrating steady-state analysis with transient evaluation. A simplified steady-state 1-D model was developed to analyze the effects of heat exchanger UA values under vehicle speeds of 15 to 120 km/h. Optimal UA combinations were determined for a target coefficient of performance (COP) of approximately 4.45 and converted into heat exchanger design parameters for transient simulations. The results showed that increasing only the chiller or evaporator UA provided limited COP improvement because of bottleneck effects on the low-pressure side, whereas simultaneous enlargement of both components achieved the target COP with the lowest total UA. Under repeated Worldwide Harmonized Light Vehicles Test Procedure (WLTP) cycles, increasing the design speed from 15 to 120 km/h reduced the average compressor power from 0.983 to 0.765 kW and increased the COP from 3.54 to 4.55, while vehicle efficiency increased from 6.56 to 6.79 km/kWh.
No takes yet. Share an insight, caveat, or question.
Hak Soo Kim (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: