Answers are grounded in this paper and cite their sources.
To improve the sulfate resistance of recycled mortar, waste glass fine aggregate (WGFA) and waste glass powder (GP) were used to partially replace recycled fine aggregate and cement, respectively. Sulfate wet–dry cycling tests were conducted on the mortar specimens using a 5% Na2SO4 solution. Sulfate resistance was assessed using mass loss rates and compressive corrosion resistance coefficients, while microstructural changes were examined by scanning electron microscopy with energy-dispersive X-ray spectroscopy (SEM-EDS), thermogravimetric analysis (TGA), and mercury intrusion porosimetry (MIP). Among the four mixtures, S20P15 (20% WGFA and 15% GP) exhibited the best sulfate resistance after 120 cycles, with a mass loss rate of 3.8% and a compressive corrosion resistance coefficient 13.3% higher than that of the control. MIP and SEM observations showed that S20P15 had relatively lower total porosity and fewer visible cracks, consistent with its improved durability. TGA revealed differences in thermal decomposition characteristics among the mixtures. The observed performance may be related to changes in aggregate grading, pore structure, and hydration-related characteristics associated with the combined incorporation of WGFA and GP. These findings support the potential use of waste glass in recycled mortar exposed to sulfate-rich environments.
No takes yet. Share an insight, caveat, or question.
Ren et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: