Answers are grounded in this paper and cite their sources.
Robotic kiwifruit harvesting requires compact grippers that accommodate fruit-size variation while transmitting sufficient force without excessive stress. This study examined the effects of the compliance constraint, volume fraction, and intermediate pseudo-density threshold on a displacement-driven topology-optimized gripper, then re-optimized a selected layout within a shortened domain and refined critical features. The monolithic PA2200 gripper was manufactured by selective laser sintering and assessed through finite element analysis, stereo digital image correlation, and load-cell testing. The 132 mm × 102 mm × 10 mm prototype weighed 17.96 g. Simulations predicted approximately ±11 mm of unloaded finger motion and per-finger reaction forces of 50.99 and 59.17 N at representative small- and large-fruit positions, respectively. The predicted peak stress reached 27.96 MPa during extended opening, remaining below the allowable stress of 28.2 MPa established using a safety factor of 1.5. With measured input displacements imposed in simulations, trial-averaged mean absolute output-displacement errors were below 0.06 mm. Loaded comparisons using measured input forces and output positions as boundary conditions showed a maximum absolute per-finger force difference of 0.97 N. These results show that the compact design can retain nominal motion and force transmission while satisfying the adopted stress criterion; laboratory comparisons support its local mechanical response under matched conditions but do not establish damage-free fruit handling or harvesting performance.
No takes yet. Share an insight, caveat, or question.
Le et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: