Answers are grounded in this paper and cite their sources.
Tests reveal fatigue strength variations in carbon-filled plastics influenced by milling modes and negative temperature impacts.
The results of tests to assess changes in the fatigue strength of carbon-filled plastics depending on milling modes during their machining and on the influence of negative temperature are presented. The tests have been carried out on samples of carbon-filled plastics of three series, differing in used cutting modes (the speed of rotation of a cutter at the same feed). Each series was manufactured in three sets to assess the strength change after exposure at positive temperature and at -50 °C for 60 and 120 hours. The tests were carried out by the method of cyclic bending three-point loading for a given amount of deflection with the recording of voltage changes every 5∙103 cycles. The total number of cycles is 105, the frequency of cyclic loading is 5 Hz. According to the test results, it was found that carbon-filled plastics obtained by milling with the lowest milling speed had the best fatigue strength characteristics. Reducing the speed of the milling cutter leads to an increase in the maximum deflection, while ensuring the best quality of the cut surface. After exposure to negative temperature conditions, the destruction of all series of samples occurs with less effort, while an increase in the maximum deflection is observed. The influence of negative temperature leads to an increase in the intensity of strength reduction with an increase in loading cycles.
No takes yet. Share an insight, caveat, or question.
Bolotnikov et al. (2023) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: