Answers are grounded in this paper and cite their sources.
Observational analysis of thermoelectric generators shows power increases with cross-sectional area in micromodules, suggesting material choice is critical.
The parameters of micromodules for thermoelectric generators used at low heat fluxes and a cold junction temperature of 310 K are estimated. For the branches of micromodules, the authors consider their own developments of fine-crystalline materials based on Sb2Te3–Bi2Te3 solid solution p-type conductivity and Bi2Te3–Bi2Se3 solid solution n-type conductivity obtained by hot pressing and extrusion of powders prepared by grinding an ingot and methods of rapid crystallization of the melt: by spinning the melt and crystallization of the melt in a liquid. Higher power is obtained on modules whose branches are made of p- and n-type conductivity materials obtained by extrusion of granules prepared by crystallization of the melt in water. The dependences of the micromodule power on the temperature difference, thermoelectric properties (Seebeck coefficient, specific electrical conductivity and thermal conductivity) of the p- and n-branch materials, their number, cross section and height are calculated. It was found that with an increase in the cross-sectional area of the branches, the generated power of the module also increases. If the height of the branches increases, then the generated power of the micromodule decreases.
No takes yet. Share an insight, caveat, or question.
Никулин et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: