Answers are grounded in this paper and cite their sources.
Experimental investigation identifies tool wear in electrodes during electrical discharge machining, suggesting a new measurement approach.
The present experimental investigation proposes an image-based assessment method for the automatic detection and measurement of convex end wear in cylindrical brass electrodes used during Electrical Discharge Machining (EDM) of AISI 314 steel plate workpieces. Minitab was utilized to determine the total number of experiments required for this study. The MATLAB Image Processing Toolbox was employed to classify and process images of cylindrical brass electrodes for extracting the data required in the data acquisition operation. The main objective of this study is to utilize a non-contact measurement system, along with a relatively low-cost instrumentation, to compute and evaluate the wear in cylindrical brass electrodes. The obtained wear values demonstrated that there is a slight skewed between the wear determined using a digitized caliper tool and the proposed image-assisted wear measurement, which validated the introduced method. The percentage of deviation between the proposed method and the method used by the digitized caliper tool-assisted wear measurement is 0.06.
No takes yet. Share an insight, caveat, or question.
Khleif et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: