Experimental and Numerical Study on the Seismic Performance of Base-Suspended Pendulum Isolation Structure

This paper proposes a novel suspended seismic structure system called Base-suspended Pendulum Isolation (BSPI) structure. The BSPI structure can isolate seismic action and reduce structural seismic response by hanging the structure with hanger rods set at the base. The viscous dampers are installed in the isolation layer to dissipate earthquake energy and control the displacement. Firstly, the configuration of suspension isolation layer and mechanical model of the BSPI structure are described. Then, an equivalent scaled BSPI structure physical model was tested on the shaking table. The test results demonstrate that the BSPI structure has a good isolation effect under earthquakes, and the viscous dampers had an obvious control effect on the structure’s displacement and acceleration response. Finally, numerical simulation of the tests was carried out. The accuracy of the numerical models are confirmed by the good agreement between the simulation and test results. The numerical models for the BSPI structure and conventional reinforced concrete (RC) frame structure are built and analyzed using the commercial software ABAQUS. Research results indicate that the lateral stiffness of the BSPI structure is reduced greatly by installing the suspension layer, and the acceleration response of BSPI structure is significantly reduced under rare earthquakes, which is only 1/2 of that of the RC frame. The inter-story displacement of the BSPI structure is less than 1/100, which meets the seismic fortification goal and is reduced to 50% of that of the BSPI structure without damper under rare earthquakes.