Key points are not available for this paper at this time.
Abstract Aims This study aimed to investigate the feasibility and effectiveness of utilizing three-dimensional (3D) printing technology in the simulation teaching of congenital malformations. Methods We conducted a comparative analysis between an experimental group that received traditional teaching supplemented with 3D printing model demonstrations and hands-on model operation, and a control group that received traditional teaching methods. Various parameters, including classroom interest, classroom interaction, learning enthusiasm, disease awareness, teaching satisfaction, and independent operation confidence, were assessed, along with theoretical and practical tests. Results The results showed no significant difference in theoretical test scores between the two groups (91.92 ± 15.04 vs. 89.44 ± 14.89), but the practical test revealed a significantly higher number of qualified trainees in the experimental group compared to the control group (23 vs. 8). In terms of classroom engagement, both groups exhibited similar levels of interest (8.08 ± 1.52 vs. 8.74 ± 0.984), classroom interaction (7.88 ± 1.97 vs. 8.7 ± 1.33), learning enthusiasm (8.81 ± 1.021 vs. 8.52 ± 1.189), and disease awareness (8.58 ± 0.99 vs. 8.58 ± 0.99). However, the experimental group demonstrated significantly higher teaching satisfaction (8.81 ± 1.06 vs. 9.19 ± 0.96) and greater operation confidence (7.67 ± 2.56 vs. 5.5 ± 2.79) than the control group. Conclusion 3D printing technology can be effectively utilized to create surgical teaching models, enhancing the confidence of standardized training doctors and improving teaching outcomes.
Gao et al. (Sun,) studied this question.