Key points are not available for this paper at this time.
Thermo-hydro-mechanical (THM) densification is a well-known wood modification procedure for improving the mechanical properties of low-density wood species, but its performance at elevated temperatures is not well understood. The objective of this study was to determine the bending behaviour of densified Scots pine at elevated temperatures. A total of 48 specimens (200 mm (longitudinonal) × 20 mm (radial) × 20 mm (tangential)) were tested to investigate the bending performance under constant temperatures at 25, 50, 125 and 175°C, respectively. It was found that the modulus of rupture (MOR) and modulus of elasticity (MOE) of both un-densified and densified pine decreased with increasing temperature. However, the densified wood exhibited more brittle shear failure but retained higher MOR and MOE than the untreated specimens treated at the same temperature level. In general, the results demonstrate that densification can be a potentially effective method to retain the mechanical properties of wood at elevated temperatures, thereby having a potential maintain the load-bearing capacity during and after fire.
Han et al. (Fri,) studied this question.