Answers are grounded in this paper and cite their sources.
The photocatalytic degradation of organic compounds is seen as a pivotal water treatment technology. While 3D printing has been proven to directly produce photocatalytic reactors, research in this area, especially utilizing mass-production-capable vat photopolymerization (VP)-based 3D printing, remains in its early stages. This study aimed to prepare high-solid content printing slurries (up to 50 wt %) using the common TiO2 nanoparticle (P25) photocatalyst to rapidly print reactors with high photodegradation efficiency. The 3D-printed photocatalytic reactors, made by using the prepared slurry, successfully demonstrated complete 100% photodegradation of common organic synthetic dyes (methylene blue, safranin O, and brilliant green). Moreover, photocatalytic reactors with triply periodic minimal surface (TPMS) structures were successfully printed. The reactors with a Diamond structural (D-type) design showed a reaction rate constant of 0.0127 min–1, which is 2.4 times higher than that of the Fischer-Koch S structural (F-type) reactors at 0.005 min–1, underscoring the significant impact of reactor structural design on photodegradation efficiency. Finally, the study showcased the potential for direct manufacturing through the batch production of photocatalytic reactors via whole build-plate 3D printing. Achieving high-speed fabrication, the process was completed within 120 min on a 19.2 cm by 10.8 cm build platform, accommodating the batch printing of 10 photocatalytic reactors, each 1.3 cm in diameter and 2 cm in height.
No takes yet. Share an insight, caveat, or question.
Chen et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: