Key points are not available for this paper at this time.
Additive manufacturing (AM) can create net or near-net-shaped components while simultaneously building the material microstructure, therefore closely coupling forming the material and shaping the part in contrast to traditional manufacturing with distinction between the two processes. While there are well-heralded benefits to AM, the widespread adoption of AM in fatigue-limited applications is hindered by defects such as porosity resulting from off-nominal process conditions. The vast number of AM process parameters and conditions make it challenging to capture variability in porosity that drives fatigue design allowables during qualification. Furthermore, geometric features such as overhangs and thin walls influence local heat conductivity and thereby impact local defects and microstructure. Consequently, qualifying AM material within parts in terms of material properties is not always a straightforward task. This article presents an approach for rapid qualification of AM fatigue-limited parts and includes three main aspects: (1) seeding pore defects of specific size, distribution, and morphology into AM specimens, (2) combining non-destructive and destructive techniques for material characterization and mechanical fatigue testing, and (3) conducting microstructure-based simulations of fatigue behavior resulting from specific pore defect and microstructure combinations. The proposed approach enables simulated data to be generated to validate and/or augment experimental fatigue data sets with the intent to reduce the number of tests needed and promote a more rapid route to AM material qualification. Additionally, this work suggests a closer coupling between material qualification and part certification for determining material properties at distinct regions within an AM part.
Stopka et al. (Tue,) studied this question.