Answers are grounded in this paper and cite their sources.
This analysis shows improved ductility in high-strength steel through annealing, revealing grain size impact on mechanical properties.
The problem of increasing the plasticity of especially low-carbon high-strength steel for the die forging of car body safety parts of complex shape is considered. Traditionally, steels of this class are cold-rolled rolled products with annealing in continuous-type broaching units. At the same time, the disadvantages of this rolled product are the variation in mechanical properties along the length of the strip and the increased cost. The solution to these problems may be a change in the production technology with annealing in bell furnaces of periodic action. However, it is precisely for this class of steels the use of bell-type annealing often leads to a decrease in elongation values during breaking t testing of the material. The reasons for the decrease in the ductility of steel during annealing in bell furnaces have been investigated, and it is shown that the main reason is the heterogeneity of the material grains. The reasons for obtaining different grain sizes were studied, and the negative nature of FeTiP inclusions was revealed. Mathematical modeling of the conditions for the formation of inclusions during annealing was carried out and boundary conditions were determined that exclude the presence of undesirable inclusions and, consequently, different grain sizes during annealing. According to the results of the testing, rolled sheets of high-strength, especially low-carbon steel with annealing in bell furnaces were produced, which fully comply with the requirements of the standards.
No takes yet. Share an insight, caveat, or question.
Gubanov et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: