Answers are grounded in this paper and cite their sources.
Pilot study shows significant reductions in water-cut and increased oil rates, highlighting effective flooding strategies.
The southern sector of the mature oil field N has a primary recovery of around 42.6% due to relatively favorable reservoir conditions (high pay thickness, high permeability, active edge water drive, moderate viscosities of 10-25 cP) in K-I sand. Therefore, laboratory studies recommended a tertiary recovery method using Surfactant Polymer (SP) Flooding for altering the subsurface reservoir/oil parameters to reduce the residual oil saturation and improve the displacement and sweep efficiency. A pilot project comprising of a normal five spot pattern with 6 months surfactant slug and 2 ½ years of chase polymer slug is under progress since March 2023. The objectives of the pilot study are to test the efficacy of the process in active water drive, gain operating experience, establish monitoring programs and evaluate techno-economics for field implementation. The SP pilot was implemented by converting four existing producers into injectors at the structural updip part of the block. The monitoring approach is divided into two programs: the injection plan and the production plan. The injection plan consisted of key parameters such as injection rate, injection head pressure, viscosity of the slug, surfactant concentration, polymer concentration, co-solvent concentration and total salinity. These were based on laboratory and core flooding studies done to achieve continuous microemulsion phase. Other parameters like dissolved oxygen, iron, turbidity, hardness, oil and grease content, pH, filter ratio, SRB, etc., are measured for injection quality control. This injection plan is one of the key reasons for the success of the chemical flood. The production plan consisted of the pattern and offset producers’ response recorded in terms of changes in water-cut, produced chemical slug concentrations, liquid withdrawal, and oil rates and thereby mapping of the movement of the chemical slug. Time-lapse saturation monitoring in injectors and producers, and changes in oil and water composition with flooding are also monitored. The direct producer witnessed a water cut decline from 80%-60%, and the oil rate improved by over 600% (3 m3/d to 20 m3/d). Two of the offset wells also showed improvement in terms of oil rate during the flooding process (85-300% increase in oil rate). The pilot oil rate performance is in accordance with the planned profile, while the decline in water-cut is more significant than the plan. Comprehensive monitoring and quality control procedures are followed to ensure smooth operations. Pilot performance demonstrated the process’s effectiveness within two years for K-I sand which has high pay thickness and strong aquifer drive. During the process, challenges encountered were in regard to downhole equipment failures, loss of productivity, measurement methodology of produced chemical concentration and chemical quality assurance. This paper introduces the field with its historical production and then deliberates the operational aspects, quality control, monitoring program, performance analysis and challenges faced in SP flooding.
No takes yet. Share an insight, caveat, or question.
Dadlani et al. (2025) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: