Answers are grounded in this paper and cite their sources.
Demonstrates a low-cost workflow for 3D prototyping in education, suggesting its feasibility for resource-constrained labs.
This study proposes and demonstrates a low-cost, reproducible scan-to-print workflow targeting resource-constrained laboratories. The objective is to integrate 3D digitization and fabrication into project-based courses using widely available tools. A five-phase protocol—image capture, image processing, CAD modeling, manufacturing, and verification—was designed and implemented with smartphone photogrammetry, accessible software, and FFF printing. In course deployment, teams rotate roles and use portfolio-based assessment to document parameters and justify design-for-additive-manufacturing decisions. A didactic knee-orthosis served as the case study. The workflow produced a functional prototype with modest resources: ≈400 photographs, alignment ≈3 h, dense reconstruction 4–5 h, and four segmented prints totaling ≈56 h on standard FFF equipment. Observed operational trade-offs were formalized as decision checkpoints, explicitly supporting engineering reasoning, justification design choices and portafolio based documentation. Results indicate that the smartphone-based pipeline is feasible on mid-range hardware and effectively links measurement, reverse engineering, and fabrication within typical course constraints. This initial work focuses on feasibility and repeatability; educational impact and full-surface metrology will be addressed in future work.
No takes yet. Share an insight, caveat, or question.
Angeles et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: