This study investigated the improvement of the pozzolanic activity of pumice, perlite, and farin through mechanochemical activation (MCA). The properties of the materials were determined by performing XRF, XRD, and particle size and specific surface area analyses. The MCA of three different materials sourced from Türkiye was performed using a planetary ball mill, and their pozzolanic reactivity was systematically investigated. R3 test (bound water measurement) and strength activity index (SAI) test were used to evaluate pozzolanic activity. Based on the results, following MCA, the crystal structure was significantly disrupted, particularly in perlite and pumice, and the amount of amorphous phase increased more compared to farin, as confirmed by the decrease in XRD peak intensities. The amount of bound water tended to increase by increasing grinding time and grinding speed. The highest amount of bound water (7.5%) was obtained by grinding the pumice sample at 500 rpm, with ball-to-powder ratio (BPR) of 10 for 60 min. For the same material, the highest activity index (106%) was determined at 500 rpm, with a BPR of 15 and a grinding time of 60 min. In the perlite sample, the highest amount of bound water (7.07%) and the highest strength activity index (98%) were measured in the sample ground at 500 rpm for 60 min with a BPR of 15. In the farin sample, the highest amount of bound water (3.40%) was obtained at 500 rpm for 40 min with a BPR of 15, while the highest strength activity index (71.05%) was observed at 500 rpm for 40 min with a BPR of 10. The results show that the applied MCA process increases the activity of the materials.
Safa Nayır (Thu,) studied this question.