This study analyzes the joint deformation behavior of low-alloy steel P355GH and commercially pure titanium Grade 1 in thick bimetallic pack assemblies during high-temperature vacuum roll bonding (HTVRB). Rheological properties were determined using a Gleeble 3800 (800–1000 °C, 0.1–10 s−1). A 3D finite element model was developed and validated against laboratory rolling (error < 6% for force, <10% for layer geometry). Four sealed pack configurations were analyzed: nominally symmetrical (A1), asymmetrical with thin cover (A2), asymmetrical with thick cover (A3), and symmetrical (A4). For the first time, the effect of intensive combined titanium redistribution during initial rolling was quantitatively described, identified as the primary cause of longitudinal thickness variation (up to Δ = 125%) and deformation non-uniformity (ϑ = 0.32–0.96). Recommendations for industrial rolling have been established. High single-pass reduction (~20% initial passes) exacerbates titanium redistribution, risking delamination and equipment failure. A two-phase roughing strategy is recommended: a first phase with gradual reductions (5–10%) to suppress titanium flow until bonding initiation (40–50% total reduction); a second phase with higher reductions to ensure bonding and refine brittle intermetallic and carbide phases. The findings support production of geometrically precise large-sized titanium clad steel plates for power engineering and other applications.
Borisenko et al. (Wed,) studied this question.