Numerical Analysis and Experimental Verification of Radial Shear Rolling of Titanium Alloy

Numerical simulation of metal forming processes is finding increasingly wide applications in advanced industry for the optimization of material processing conditions and prediction of process parameters, finally delivering a reduction of production costs. This work presents a comparison between simulation results of radial shear rolling (RSR) of VT3-1 titanium alloy (Ti-Al-Mo-Cr-Fe-Si) and results of experimental RSR at 1060 °C, 980 °C, and 900 °C in one, three, and five passes, respectively. The digital model (DM) demonstrates a high convergence of the calculation results (calculation error of less than 5%) with the actual geometric parameters of the experimental bars, their surface temperature, and rolling time during the experiment, which indicates a good potential for its application in the selection of deformation modes. Based on the simulation and experimental data, the conditions providing for the formation of differently sized grains in the bar cross-section have been identified. All of the as-rolled bars exhibit a gradient distribution of macrostructure grain size number (GSN), from the smallest one at the bar surface (2–4) to the greatest one in the center (4–6). The macrostructure GSN correlates with the workpiece temperature, which is the highest in the axial zone of the bars, and with the experimentally observed high plastic strain figures in the surface layers. It was found that, depending on the temperature conditions and reduction ratio per pass, any minor change in the values of process parameters can lead to the formation of macrostructures with different grain size numbers.