Answers are grounded in this paper and cite their sources.
Experimental investigation optimizes drilling parameters in CF/PEEK laminates, suggesting improved tooling techniques.
Abrasive water jet (AWJ) drilling is a thermally benign method enabling damage-tolerant hole production in recyclable carbon fiber-reinforced polyetheretherketone (CF/PEEK) laminates. Using a Taguchi L18 orthogonal array, this study investigated the effects of traverse rate, water-jet pressure, and abrasive mass flow rate on surface roughness (Ra), kerf angle (θ), dimensional deviation (ΔD), and entry/exit delamination factors (Fd). To link process conditions with surface morphology, grey relational analysis (GRA) was integrated with the Taguchi method for multi-response optimization. The analysis revealed that damage mechanisms fundamentally evolve with traverse rate; lower speeds cause interlaminar delamination due to prolonged hydraulic loading, whereas higher speeds shift the damage to localized fiber fracture and erosion. Notably, entry-side delamination was consistently more severe than at the exit. The optimum parameter combination to minimize all defects simultaneously was identified as 1250 mm/min traverse rate, 2000 bar jet pressure, and 350 g/min abrasive mass flow rate. ANOVA confirmed traverse rate as the most dominant factor, contributing approximately 60% to the overall hole quality. Ultimately, this study establishes a robust process window for dimensionally accurate, low-damage AWJ drilling of CF/PEEK composites, highlighting the critical role of traverse speed in governing microscale damage transitions.
No takes yet. Share an insight, caveat, or question.
Yakut et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: