Answers are grounded in this paper and cite their sources.
Demonstrates transient cavitation suppression in closed-circuit pumps, indicating effective design strategies.
Closed-circuit axial piston pumps in the travel hydraulic systems of heavy-duty engineering vehicles are highly vulnerable to severe transient cavitation during emergency braking. Rapid pressure reversal at the interface between the cylinder bore and the valve plate causes volumetric efficiency loss, intensified pressure pulsation, and erosion damage; however, the coupled mechanism by which throttling, vortex formation, and cavitation interact in this region, together with its structural regulation pathway, remains insufficiently understood. To address this gap, a closed-circuit axial piston pump for cotton pickers was investigated under emergency braking as a representative extreme loading scenario. A full-passage transient CFD model was established and validated against steady-state volumetric efficiency tests on a heavy-load test bench, as well as against PIV internal flow visualization on a Reynolds-scaled transparent model. Parametric transient CFD sweeps were then performed, and a multi-objective optimization model was developed and solved using a Kriging-assisted NSGA-II algorithm with entropy-weighted TOPSIS decision-making. The results identify the interface between the cylinder bore and the valve plate as the primary cavitation zone, with cavitation driven by local throttling and wall-attached vortices rather than by global low pressure. The optimized cylinder bore configuration reduces the peak gas volume fraction by 34.7% in the total flow domain and by 15.7% in the valve plate region, while maintaining volumetric efficiency above 97.8%; the port plate pressure pulsation increases by 12.97%. The key takeaway is that targeted optimization of the cylinder bore alone, without altering the overall valve plate or piston block architecture, can effectively suppress transient cavitation, while revealing an inherent trade-off with pressure pulsation control. In conclusion, this work clarifies the cavitation mechanism, provides a validated numerical and experimental framework, and offers an implementable design pathway for transient cavitation control of closed-circuit piston pumps under extreme loading conditions.
No takes yet. Share an insight, caveat, or question.
Wang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: