Answers are grounded in this paper and cite their sources.
Investigates recycling zirconia waste for dental ceramics, highlighting a sustainable fabrication method.
Backgrounds and aim Recycling of dental zirconia waste, primarily from 3%-mol yttria-stabilized tetragonal zirconia (3Y-TSZ), presents challenges due to the material’s intrinsic mechanical and chemical stability. This study investigates a hydrothermal treatment combined with ball milling to facilitate the recycling of zirconia and optimize granulation via spray-drying for use in dental prosthetics. Materials and methods Zirconia waste from pre-sintered blanks was subjected to hydrothermal treatment at 275°C and 10.5 MPa, followed by wet ball milling. The milled powders were used to create slurries with varying solid content, dispersant, and binder levels, which were then spray-dried. Results Particle size analyses revealed that hydrothermal treatment significantly reduced milling time and particle size, yielding finer powders compared to untreated zirconia. The optimized slurry formulation, containing 70 wt% solid content and 0.3 wt% dispersant, was granulated into microspheres, achieving spherical morphology and uniform size distribution. Conclusion The study demonstrates the feasibility of recycling zirconia waste using a combined hydrothermal and spray-drying approach, providing a sustainable route for fabricating dental ceramics.
No takes yet. Share an insight, caveat, or question.
Valian et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: